Basement Drying >> The Best Ways To Dry Out A Flooded Basement

If your house has been substantially damaged or is being substantially improved, your community’s floodplain management ordinance or law will not allow you to have a basement, as defined under the National Flood Insurance Program (NFIP). The NFIP regulations define a The Best Ways To Dry Out A Flooded Basement asement as "any area of a building having its floor subgrade on all sides. 

If your house has such a basement, you will The Best Ways To Dry Out A Flooded Basement be required to fill it in as part of any retrofitting project. Note that the NFIP definition of basement does not include what is typically referred to as a "walkouton-grade basement, whose floor would be at or above grade on at least one side. 

As barriers, levees and floodwalls can block The Best Ways To Dry Out A Flooded Basement access to your house. If you build a levee or floodwall, you will usually need to provide openings or other means of access for driveways, sidewalks, and other entrances, but any opening in a floodwall or levee must be closed when flooding threatens. A variety of closure mechanisms are available. 

For floodwalls these include shields similar to those used in dry floodproofing (as described earlier in this chapter) that are hinged to the wall or The Best Ways To Dry Out A Flooded Basement designed to slide into place. Prefabricated panels stored elsewhere when not in use are also acceptable (see Figure 7-16). 

Acceptable closures for levees include permanently mounted, hinged or sliding flood gates and The Best Ways To Dry Out A Flooded Basement prefabricated stop logs or panels. An alternative to incorporating openings is to provide a means of crossing over the top of a levee or floodwall. If a levee is low enough, a ramp can be created with additional fill material. 

Similarly, a stairway can be built over a low floodwall, as shown in Figure 7-17. human The Best Ways To Dry Out A Flooded Basement intervention. Your levee or floodwall will not protect your house from flooding unless you are willing and able to operate all closure mechanisms before flood waters arrive. 

Building a levee or floodwall around a house keeps flood water out of the protected area, but it can also keep water in – water that The Best Ways To Dry Out A Flooded Basement collects from rain or snow and from seepage during floods or, in the worst case, water that overtops the levee or floodwall. 

Two methods of removing this water should be used for all levees and floodwalls: drains and sump pumps. The Best Ways To Dry Out A Flooded Basement Drains installed at the base of a levee or floodwall allow collected water to flow out of the protected area. 

The outlets of the drains must be equipped with flap valves that close automatically during flooding to prevent flood water from backing up through the drains into the The Best Ways To Dry Out A Flooded Basement protected area. An electric sump pump should be installed at the lowest point inside the protected area. 

The pump must have an adequate capacity – it must be able to remove water from the The Best Ways To Dry Out A Flooded Basement protected area faster than water enters. An emergency power source, such as a gasoline-powered generator, should be provided so that the pump will continue to operate during interruptions in electrical service, a common event during a flood. 

Whenever The Best Ways To Dry Out A Flooded Basement possible, the downspouts from the roof of the house should be directed over the levee or floodwall so that they will not contribute to the collection of water in the protected area. Inspection and Maintenance After a levee or floodwall is constructed, you must inspect it periodically and make whatever repairs are necessary. 

Otherwise, small problems, such as The Best Ways To Dry Out A Flooded Basement settlement, cracking, loss of vegetation, and minor amounts of erosion and scour, can quickly become major problems during a flood. At a minimum, you should perform these inspections each spring and fall, before each impending flood if you have adequate warning, and after each flood. 

Protecting Service Equipment Protecting a house with a levee or floodwall also protects any service equipment inside the house. Also, when levees and floodwalls protect not The Best Ways To Dry Out A Flooded Basement only the house but an area around it as well, service equipment mounted on exterior walls, such as an electric meter, and equipment installed near the house, such as an air conditioning compressor, will be protected. 

But any equipment outside the protected area must be relocated, elevated, or anchored. Chapter 8 discusses the The Best Ways To Dry Out A Flooded Basement protection of service equipment. Levee Construction The design professional must conduct an analysis of the soil at the site to determine whether it is adequate for use in the levee and to anticipate any foundation and seepage problems. 

When you construct a levee, you should try to take advantage of the natural terrain around your home. Depending on the topography of your lot, the levee may not have to completely encircle your house. You may be The Best Ways To Dry Out A Flooded Basement able to build the levee on lower ground and tie the ends into higher ground. 

An advantage of this technique is that the levee can often be made to look like part of the natural topography of your lot. In preparation for construction, all ground vegetation and topsoil should be removed from the The Best Ways To Dry Out A Flooded Basement levee site. Sod should be set aside so that it can be used on the surface of the levee after construction. 

The levee should be built up in 6-inch layers, each of which must be compacted. If there is a shortage of impervious soils in the area, the levee can be built with an The Best Ways To Dry Out A Flooded Basement impervious core and the available permeable soils can be used for the outer part of the levee, as shown in Figure 7-18. The core can be made of impervious soils or another type of water-resistant barrier. 

The core will minimize The Best Ways To Dry Out A Flooded Basement seepage through the levee; however, the use of permeable soils on the outside of the levee will require that the angle of the side slopes be reduced so that scour and erosion are minimized. This is an important If the soil underlying the levee is highly permeable, an impervious barrier may have to be constructed below the levee to control foundation seepage. 

Several types of The Best Ways To Dry Out A Flooded Basement barrier designs are available, but they are normally used for major levee projects and would usually be too expensive for a homeowner. The analysis of the soil at the site will reveal such problems. As noted earlier, the height of the levee will depend on the FPE and the need for at least 1 foot of free board. 

Also, the levee should be built at least 5 percent higher than the desired elevation. This additional height will compensate for settlement of the soil that occurs naturally after construction. Levees are constructed with compacted layers of soil. When an adequate amount of impervious soil is not available, the levee can be constructed of permeable outer soils and an The Best Ways To Dry Out A Flooded Basement impervious core.

Commercial Building Drying And Mold

MOLD/WATER DAMAGED MATERIALS Key Engineering Controls and Work Practices Discard all water-damaged materials, materials that are visibly coated with mold that cannot be properly cleaned, such as porous materials (e.g., carpeting, drywall, insulation), and Structural Drying Commercial Building Drying And Mold materials that have been wet   read more..

What Does A Forensic Document Examiner Do

If the existing binding is too deteriorated to retain, Document restoration What Does A Forensic Document Examiner Do the book may be rebound in a binding made of new materials of conservation quality. A laced-in structure (Figure 4) is often chosen by conservators for books that are to be bound in leather.

When properly constructed this is  read more..

Roof Damage Insurance Claim In North Carolina

The primary key to good shingle performance is the use of self-seal adhesive, coupled with correct application of fasteners (Smith, 1994). With an adequate number of fasteners, the pull-through resistance of the shingle will determine whether the loss of adhesive seal leads to the shingle being lost  read more..

Asbestos Mitigation

Basically asbestos comes from a group of naturally occurring minerals, with fibers that are of a thin elongated mass which can be separated easily from its strands. These minerals have excellent insulating value, highly resistant to heat and chemicals with flexible fibers that can be woven ea  read more..

How To Dehumidify Your Water Damaged Home

Figure 2 shows a picture of the experimental system. The evaporator and condenser chambers are Dehumidification How To Dehumidify Your Water Damaged Home shown in the center of the picture. Both are wrapped with black polyethylene foam insulation to prevent heat transfer to or from the ambient environment. The air and water piping is also cov  read more..

Mold Remediation

If there has been a lot of water damage, and/or mold growth covers more than 10 square feet, consult EPA's Mold Remediation in Schools and Commercial Buildings. Although focused on schools and commercial buildings, this Water Extraction Mold Remediation article is applicable to other building types. If you choose to hire   read more..

Start A Radon Testing Business

PROGRAM REQUIREMENTS FOR MEASUREMENT SERVICE PROVIDERS Adherence to all of the following requirements constitutes an EPA-conforming measurement.Participants involved in measurements for real estate transactions must also follow all procedures described in this section (Section 4.2), as well as those  read more..

How To Remove Lead Paint From Walls

Nine test kits (both chemical types) were used to test for the presence or absence of lead in a set of six alkyd oil-based paint standards prepared by CPSC's Directorate for Laboratory Sciences, Division of Chemistry (LSC) staff (at lead concentrations of 0.0 percent, 0.06 percent,0.10 percent, 0.50  read more..

Frozen Pipe Cost

Household Plumbing TipsThe City of Phoenix Water Services Department has almost 7,000 miles of water mains throughout the city.Phoenix Water Services is responsible for repairing all leaks, broken pipes, and water mains on the city, or Water Damage Frozen Pipe Cost street side of the water meters. 

  read more..

How To Remove Asbestos Siding

The following recount criterion is for a pair of counts that estimate AC in fibers/cc. The criterion is given at the type-I error level. That is, there is 5% maximum risk that we will reject a pair of counts for the reason that one might be biased, when the large Asbestos Abatement How To Remove Asbestos Siding observed differen  read more..