Flood Damage >> Storm And High Flood Damage Prevention Plan

Mold, mildew and bacteria are common following floods and other water damage. If unchecked they can lead to sanitation and health problems. The walls, floors, closets, shelves, contents-every flooded part of your house-should be thoroughly washed and disinfected.In most cases, Storm And High Flood Damage Prevention Plan household cleaning products will do the job if you use them correctly.

Check the label on the products to see how much to use. Some products shouldn't be used on certain materials; the label will tell you that. Apply cleaner and give it time to work before you mop or sponge it up. Follow directions and all safety precautions on the container. After cleaning a room or item, Storm And High Flood Damage Prevention Plan go over it again with a disinfectant to kill the germs and smell left by the floodwaters.

Cleaning Tips Tackle one room at a time. A two-bucket approach is most efficient: use one bucket for rinse water and the other for the cleaner. Rinse out your sponge, mop, or cleaning cloth in the rinse bucket. Wring it as dry as possible and Storm And High Flood Damage Prevention Plan keep it rolled up tightly as you put it in the cleaner bucket. Let it unroll to absorb the cleaner.

Using two buckets keeps most of the dirty rinse water out of your cleaning solution. Replace the rinse water frequently. Walls Start cleaning a wall at the bottom or where the worst damage was. If you did not have to remove the wallboard or plaster, you may ind that the wallboard or Storm And High Flood Damage Prevention Plan plaster won't come clean and you will want to replace it rather than clean it.

If you have removed the wallboard or plaster, wash the studs and sills and disinfect them. Wood alcohol or turpentine applied with a cotton ball may remove white mildew spots on wood. Cream wood restorers and lanolin will help restore good wooden furniture.Upholstered furniture soaks up contaminants from floodwaters and Storm And High Flood Damage Prevention Plan should be cleaned only by a professional.

This is also true of carpets and bedding. Unless the piece is an antique or very valuable, upholstered furniture soaked by floodwaters should probably be thrown out.Clothing and Linens Even if your washing machine did not get wet, Storm And High Flood Damage Prevention Plan do not use it until you know that the water is safe enough to drink and that your sewer line works. Before you wash clothes in the washing machine, run the machine through one full cycle.

Be sure to use hot water and a disinfectant or sanitizer. Take clothes and linens outdoors and shake out dried mud or dirt before you wash them. To prevent a drain clog, hose off muddy items to remove all dirt before you put them in the washer. Check the labels on clothes and linens, Storm And High Flood Damage Prevention Plan and wash them in detergent and warm water if possible.

Adding chlorine bleach to the wash cycle will remove most mildew and will sanitize the clothing, but bleach fades some fabrics and damages other fabrics.You can buy other sanitizers, such as pine oil cleaners, Storm And High Flood Damage Prevention Plan at the grocery store to sanitize fabrics that cannot be bleached. If the label says "Dry Clean Only," shake out loose dirt and take the item to a professional cleaner.

If you want to clean leather yourself, wash the mud off and dry the leather slowly away from heat or Storm And High Flood Damage Prevention Plan sunlight.Appliances There is an unexpected danger of shock with some electrical appliances such as TV sets and radios. Certain internal parts store electricity even when the appliance is unplugged.

Check the back for a warning label. Appliances with such labels will need professional cleaning.You will need appliances such as the washing machine, dryer, dishwasher, and vacuum cleaner to help clean your house and its contents. The motors or heating elements can usually be cleaned. If you cannot wait for a professional cleaning job, unplug, disassemble, Storm And High Flood Damage Prevention Plan and hose off the appliances thoroughly (with hot water, if possible).

Then clean and disinfect them, but do not use detergents. Clean and disinfect dishwashers, clothes washers and dryers only with water that has been declared safe for drinking. Make sure the sewer line is working before you start a dishwasher or washing machine. Storm And High Flood Damage Prevention Plan

You can speed up the drying process for motors and parts by using a blow dryer or a moisture displacement spray. Moisture displacement sprays, such as electronics parts cleaners or WD-40 lubricating and Storm And High Flood Damage Prevention Plan penetrating oil can also stop rust and corrosion until the appliance can be disassembled and cleaned.

One word of caution: The spray is flammable. Read and follow label instructions and precautions. Moving parts such as motors and pulleys will need oil or grease.Contacts and electrical switches can be cleaned with moisture displacement spray or Storm And High Flood Damage Prevention Plan an aerosol contact cleaner available at electronics or auto parts stores.

Allow a motor to run for 30 minutes with no load before using it. Watch for stripped or damaged insulation around wires. Be sure all appliances are properly grounded.Appliances that must be grounded have a round third prong or a grounding wire on their plug. Refrigerators, freezers and Storm And High Flood Damage Prevention Plan ovens are more complicated.

They may have foam insulation and sealed components that suffered little water damage. But these appliances hold food, and so they should be cleaned, disinfected and checked by a professional or Storm And High Flood Damage Prevention Plan replaced. Kitchen Items Throw out soft plastic and porous items that probably absorbed whatever the floodwaters carried in.

Floodwaters are contaminated, so you may want to wash dishes by hand in a disinfectant. Air dry the disinfected dishes; do not use a dishtowel. The dishwasher should also be used only after you know your water is safe to drink and Storm And High Flood Damage Prevention Plan your sewer line works.

Clean and disinfect it first. Then use a hot setting to wash your pots, pans, dishes, Storm And High Flood Damage Prevention Plan and utensils. (If you have an energy saving setting, do not use it.)Food Throw out any food that has been touched by floodwaters. Even food in tin cans should be discarded if the cans got wet during the flood because there is no way to be absolutely certain the food inside is safe.

Do not keep food in bottles or jars with bottle caps or screw on lids-they do not keep out loodwaters. For more information on safe food handling, go to www.FoodSafety.gov : Disaster Assistance or call FDA's toll-free information line at 1-888-SAFEFOOD (1-888-723-3366). Storm And High Flood Damage Prevention Plan

Hoarding And Housecleaning

There are clouds in the painting, of course. Almost any one of us would have included those clouds, thick with electricity and rainwater. And there is the wheat field, smudged out like an empty palm, orange beneath the storm-stricken sun. Surely, many of us would have insisted on the wheat as well.   read more..

Mold Removal

Clean Water Extraction Mold Removal off hard surfaces with water and detergent, and dry completely. Absorbent materials such as ceiling tiles, that are moldy, may need to be replaced. Prevent condensation: Reduce the potential for condensation on cold surfaces (i.e., windows, piping, exterior walls, roof, or floors)   read more..

Remove Fire Smoke Smell From Clothes

This section addresses the use of masks and respirators by the public and workers to reduce inhalation of wildfire smoke, specifically harmful particles. Use of the term "mask" in this context may cause confusion for both public health officials and the general public, as it can refer to one-strap p  read more..

How To Get A Smoke Smell Out Of Ceiling Beams Afte

Do not enter the damaged site. Check with the fire department to make sure your residence is safe. Do not cut or walk past colored tape placed over doors or windows to mark damaged areas unless local authorities advise that it is safe to do so. Remember, fires can rekindle from hidden, Smoke Damage How To Get A Smoke Smell Out Of Ceiling Beams Afte smolderi  read more..

Radon

The EPA recommends that you should have a qualified radon mitigation contractor Radon Mitigation Radon your home because lowering the high radon gas levels requires a specific technical knowledge and a special set of skills. Without the proper tools and equipment or the technical knowledge, you might actually   read more..

Dehumidification

The very first step in any water damaged document restoration is to document very item and categorize them to resemble some kind of system. To assist in the documentation  step is good to light and separate dry, damp and water soaked documents. Upon the recommendation of the supervisor overs  read more..

Roof Leak Mold

Initial Restoration for Flooded Buildings Hurricane Katrina Recovery Advisory November 2005 FEMA Part 1 NOTE: This advisory is specifically intended for buildings subject to the effects of long-term flooding and widespread mold growth following Hurricane Katrina. For additional information on more c  read more..

Types Of Security For Fenced Yards

Storm surge levels on Galveston Island and on the west side of Galveston Bay are estimated to be between 10 and 15 ft. Here, too, several NOS tide gauges failed, although the gauge at Eagle Point on the west side of Galveston Bay recorded a maximum surge of 11.48 ft.The highest inundation, of at lea  read more..

Radon Gas Measurement Methods

AC - Activated Charcoal Adsorption For this method, an airtight container with activated charcoal is opened in the area to be sampled and radon in the air adsorbs onto the charcoal granules. At the end of the sampling period, the container is sealed and may be sent to a laboratory for analysis.The g  read more..

Ceiling Leak Mold From Pipe Break

However, this relationship could not be proven by experimental investigations on other materials. Scheffler (2008)showed measurement results for a calcium silicate insulation material and a ceramic brick. Both materials have a distinct first drying phase. All results indicated a linear relationship   read more..