Structural Drying >> Mold Mitigation

These Mold Mitigation tracks are traits of Douglas-fir, pines, spruces and larches and are readily visible to your naked eyes, or under a low power magnifier on the end grains of planks and logs. In ponderosas, white and sugar pines, resin tracks are obviously visible as thin, brown stripes on the surfaces of lumber. Sometimes, other species might create localized bands of vertical resin tracks in response to pain to the cambium, i.e. western hemlocks and redwoods.

  1. Kiln Mold Mitigation lumber from this species would tend to set resin and reduce later exudation if lumber is subjected to heat in the modern house. The woody part of a living tree constantly is fluxed with water which is present in different forms, 'free' water as confined to the cell chasms and 'bound' water which may saturates the cell walls. The humidity substance of wood is expressed as a per cent, i.e. 50%, which is a ratio value of the mass of water to the oven-dried mass of wooden substance, represented by the Mold Mitigation formula: Per cent H.S. = Mass of water x 100 Oven-dried mass of woods.
  2. Many species usually have more wood substance per unit volume (density), i.e. comparing hickories with western red cedars. Consequently, at any given Mold Mitigation humidity substance per cent figure wood from different species actually would contain a variable quantity of water per unit volume (plank foot or cubic foot). For archetype, at 50 per cent humidity substance a plank foot of hickory might contain about two pounds of water whilst a plank foot of western red cedars might contain about one pound of waters. Of particular importance in Mold Mitigation wood is the presence of bound waters confined to the cell walls (wood substances).
  3. When any parts of the cell edifices of a piece of wood has dried to the point that any free water is extracted and only bound water endures, that wood cells involved have reached their 'fibrous saturation points' (a figure of about 45 per cent humidity substance for most practical purposes). Further Mold Mitigation extracts bound water from its close contact with the chemical cell-wall features (principally cellulose) to cause the walls of these cells impacted to shrink (or desire to shrink). The chemical features comprising the largesse of wooden substances often are pointed more or less parallel to the vertical axis of wooden cells.
  4. With water lost from between these features, it is obvious that most shrinkage happened perpendicular to the axis of all wooden cells. It isn’t that 93 per cent of the cell edifices in conifers are comprised of long, slender cells paralleling the length of logs and/or lumber. Therefore, almost 100 per cent of the shrinkage often developed in a plank is in its girth and thickness. Usually, the quantity of shrinkages in a plank might be correlated to the character and quantity of summerwood present since this substance very much controls density. Vertical shrinkage usually is very low, less than one-half of one per cent in wood of normal Mold Mitigationprogress.

What Is Radon

What is what is radon? What is radon is a radioactive gas released from the normal decay of the elements uranium, thorium, and radium in rocks and soil. It is an invisible, odorless, tasteless gas that seeps up through the ground and diffuses into the air. In a few areas, depending on local geology,  read more..

How To Report Suspected Meth Activity

Cleanup Guidelines for Properties Quarantined Due to ClandestineDrug Laboratory ActivitiesIntroduction This document is designed to assist property owners on the appropriatesteps necessary to Meth Lab Cleanup How To Report Suspected Meth Activity remove a Louisville Metro Health Department quarantine order due topresence of hazardous substance  read more..

Prevent Flood Waters From Entering

By preparing for the next flood,you regain control over your future —a guaranteed way to reduce your level of anxiety and stress. You don't have to wait for the government to act; you can take care of protecting your home when you are ready. Flood Damage Prevent Flood Waters From Entering

Floodproofing won't  read more..

Water Damage

Water is by far the single most long-term destructive substance in any indoor environment. It will dissolve or weaken many building materials and supports the growth of microorganisms like mold. Because it can flow, Sewage Cleanup Water Damage has the unique capability to carry with it a wide variety of hazardous p  read more..

Fire Damage

Odor Control, Fire damage


During a fire, the smoke could permeate the walls and other surfaces and could drift through the household ducts, where it can become trapped. If the smoke is not properly removed, smoke odor reoccurs from time to time, especially during the warm or damp  read more..

Smoke Inhalation

Exposure to Smoke inhalation from Fires The Smoke inhalation released by any type of fire (forest, brush, crop, structure, tires, waste or wood burning) is a mixture of particles and chemicals produced by incomplete burning of carbon-containing materials. All Fire Damage Smoke Inhalation contains carbon monoxide, carbon di  read more..

How To Promote Emergency Preparedness

Bomb Threat If you receive a bomb threat telephone call:Remain calm.Listen carefully. Be polite and show interest.Try to keep the caller talking to learn more information. If possible, Emergency Board up How To Promote Emergency Preparedness write a note to a colleague to call the authorities or, as soon as the caller hangs up, immediately   read more..

How To Remove Asbestos From An Apartment Building

Where more than one liquid is suggested, the first is preferred; however, in some cases this liquid will not give good dispersion color. Take care to avoid interferences in the other liquid; e.g., wollastonite in n = 1.620 will give the same colors as tremolite. In n = 1.605 wollastonite will appear  read more..

California Asbestos Tile Removal Requirements

Identifying hazardous materials before starting work on a project site protects worker health and safety, building occupants, and the financial viability of the project. Doing this up front can help you choose the appropriate inspectors, consultants and contractors and avoid costly change orders or  read more..

Lead Paint Poisoning

Lead serves no useful purpose in the body and it can cause serious and permanent health problems. How Does Lead Enter the Body? Lead enters the body by being inhaled or swallowed. Lead can be inhaled when lead dust, mist, or fumes ("smoke") are in the air. Particles of lead can be swallowed if lead   read more..