Document restoration >> How To Restore Fire Damaged Photos

When reviewing completed work, keep in mind that it is difficult to evaluate technical aspects of a treatment. A good rule of thumb is that all repairs should be discernable to a trained eye, How To Restore Fire Damaged Photos  o that those consulting the materials in the future will not be misled about an item's condition or the nature and extent of previous conservation treatment. 

Repairs should, however, be How To Restore Fire Damaged Photos visually integrated so that the eye is not immediately drawn to them, and they should not clash aesthetically or historically with the item. 

Remember that the nature and severity of damage or deterioration will influence the degree to which the item can be stabilized, strengthened, and aesthetically improved through treatment. SUMMARY Selecting a How To Restore Fire Damaged Photos conservator is a serious proposition, but it need not be daunting. 

It is important to exercise How To Restore Fire Damaged Photos caution and not rashly entrust cultural resources to a person whose judgment and skills are not commensurate with the task. By asking careful questions, contacting references, and working with the conservator before and during treatment, you will be able to obtain competent conservation services. 

In this way, the sometimes delicate chain linking the past and the future will not be broken, and these important resources will remain available to researchers now and in the How To Restore Fire Damaged Photos future. Fasteners such as staples, paper clips, string ties, rubber bands, brads, and straight pins frequently damage documents. 

The damage may be physical: puncturing, tearing or distortion such as creasing. Or chemical damage may result such as staining from the rusting of metal fasteners. Potentially damaging fasteners should be carefully removed from archival documents before they are put into long-term How To Restore Fire Damaged Photos storage. 

Fasteners should always be left in place if removing them will cause damage. Sealing How To Restore Fire Damaged Photos wax, ribbons, thread ties or stitches, and unusual metal fasteners have value as artifacts and/or enhance the value of historic documents. The decision about the retention or removal of such fasteners is a curatorial one. 

When in doubt, these should always be left in place. If records must be kept together by a fastener for the convenience of readers or staff, the National Archives now recommends that a piece of durable, alkaline paper in a card stock weight be folded over the top of the group of documents, with a How To Restore Fire Damaged Photos paper clip slipped over the protective overlay (Figure 1). 

Potentially damaging original fasteners should first be removed. Although they do not stain paper, plastic or coated metal clips will cause distortion of paper and are not recommended. 

REMOVING PAPER CLIPS 

If the paper clip has not rusted and the paper is sturdy, a How To Restore Fire Damaged Photos paper clip can be removed by gently prying it open. The safest How To Restore Fire Damaged Photos method is to place the fastened papers with the short side of the paper clip facing up and the long side against a flat surface (Figure 2).

 Holding the long side of the clip down (through the paper) with one finger, carefully pull up on the short side with the thumb-nail of the other hand. If your fingernails are not long enough to get under the short side of the clip, use a small, How To Restore Fire Damaged Photos flat tool. 

Conservators recommend microspatulas, which are How To Restore Fire Damaged Photos available from sellers of conservation or scientific supplies. With fragile papers or papers to rusted by the clip: gently insert a small piece of Mylar between the clip and the paper on both sides; position the papers, and pry open as above. 

If the paper clip is severely rusted, first loosen it from the paper by scraping through the rust layer very gently with the tip of a microspatula before inserting the Mylar and gently prying the How To Restore Fire Damaged Photos clip open. 

REMOVING STAPLES 

Do not use staple How To Restore Fire Damaged Photos removers. If the staple has not rusted, and the paper is sturdy, a staple can be removed by gently prying the prongs pen and carefully slipping them through the puncture holes. The safest method is to place the stapled papers on a flat work surface with the prongs of the staple facing up. 

Insert the tip of a microspatula between the paper and a prong of the staple and gently pry open one How To Restore Fire Damaged Photos prong at a time (Figure 3). Turn the stapled papers over and insert the microspatula between the staple and the paper, and carefully slip the prongs through the puncture holes (Figure 4). 

With fragile paper, or papers to which the staple has rusted: gently insert a small piece of Mylar between the staple and the paper on both sides (Figure 5); position the How To Restore Fire Damaged Photos papers, and pry open as above. 

Cut Mylar into How To Restore Fire Damaged Photos strips which are slightly smaller than the width of a staple (or tapered) to make the Mylar easier to insert. If the staple is severely rusted, first loosen it from the paper by scraping through the rust layer very gently with the tip of a microspatula before inserting the Mylar and gently prying prongs open and removing the staple.

 Subject to curatorial decision and/or time or labor How To Restore Fire Damaged Photos restrictions, unrusted staples may be left in place during long-term storage of historic documents, provided that environmental conditions are not conducive to rust. Staples should be carefully removed as necessary, for example for photocopying. 

STRAIGHT PINS 

If the straight pin has not rusted, and the paper is sturdy, a straight pin can be removed by gently pulling it through the How To Restore Fire Damaged Photos paper. 

With fragile papers or How To Restore Fire Damaged Photos papers to which the pin has rusted, gently insert a small piece of Mylar between the pin and the paper at all three points of contact and carefully pull the pin through the paper (Figure 6). 

If the straight pin is severely rusted, first loosen it from the paper by scraping through the rust layer very gently with the tip of a microspatula before inserting the Mylar and gently pulling the pin out. 

STRING TIES/RUBBER BANDS 

Cut the tie or band and gently lift it off. Do not attempt to pull these How To Restore Fire Damaged Photos fasteners over the ends of documents. If a rubber band has dried and adhered, gently scrape it off with a microspatula, being careful not to abrade or tear the paper. 

If the rubber band is soft and sticky, do not use solvents. Sticky residue may be gently scraped off with a microspatula. If this residue does not come off easily, interleave the sheets with silicone release paper to keep them from sticking together and consult a How To Restore Fire Damaged Photos conservator.

Homemade Home Security

Understanding the difference between National Weather Service watches and warnings is critical to being prepared for any dangerous weather hazard, including hurricanes. A watch lets you know that weather conditions are favorable for a hazard to occur.It literally means "be on guard!" During a weathe  read more..

How To Choose An Asbestos Removal

Vermiculite is a nonfibrous silicate mineral with many commercial and consumer applications. Its usefulness comes from its ability at high temperatures to expand (i.e., exfoliate) up to 20 times its original size (EPA 1991). Additionally, vermiculite has a high-ion exchange capacity, making it usefu  read more..

Symptoms Of Ocd

Obsessive compulsive disorder Treatment More information on obsessive compulsive disorder People with obsessive compulsive disorder (SYMPTOMS OF OCD ) have thoughts (obsessions) or rituals (compulsions) which happen over and over again. Rituals , such as hand washing, counting, checking on a speci  read more..

Tools For Restoring Flood Damaged Electronics

Other manufacturer-supplied test data shed light on the typical behavior of tantalum polymer capacitors after exposure to various environmental stresses. Sanyo provided data that describe the typical response of their capacitors to dry heat, moisture, solder reflow conditions, and Electronic Restoration Tools For Restoring Flood Damaged Electronics DC   read more..

Reading A Radon Detector

In order to become or remain listed, new applicants and existing participants must meet a number of programmatic requirements. Participation in the Program is voluntary; there is no Federal requirement that radon service providers participate. However, Radon Mitigation Reading A Radon Detector some state and local governments  read more..

Wind Proof Your House

During a hurricane, homes may be damaged or destroyed by high winds and high waves. Debris can break windows and doors, allowing high winds inside the home. In extreme storms, Wind Damage Wind Proof Your House such as Hurricane Andrew, the force of the wind alone can cause weak places in your home to fail.    read more..

Radon Gas Measurement Methods

AC - Activated Charcoal Adsorption For this method, an airtight container with activated charcoal is opened in the area to be sampled and radon in the air adsorbs onto the charcoal granules. At the end of the sampling period, the container is sealed and may be sent to a laboratory for analysis.The g  read more..

How To File A Flood Insurance Claim

If the flooding was widespread and caused a lot of damage, your community might be eligible for state or federal aid. To receive such assistance, your community must be declared a disaster area by your Governor, Flood Damage How To File A Flood Insurance Claim a federal agency director, or the President.

Local newspaper, radio  read more..

Mold Remediation

A second group of cells, notably wooden rays, consist of short, brick-like rudiments directed at ninety degree angles to the tree axis and extending through the inner bark towards the trunk. It is opportune at this Structural Drying Mold Remediation time to bring up the influence of wooden rays upon structural drying. Woo  read more..

Debris Removal

Other states might be in the prohibit transfer of any property where illegal drugs, like meth were manufactured unless the officials have determined the site was fit for use or, if not fit for use, unless the property seller has made a full written disclosure to the prospective property buyer  read more..